![]() The ONSIP OiD4 is a state-of-the-art mega-pixel, dual-codec (H.264, MJPEG) IP/network camera built with embedded software and hardware technology. ![]() Technical Assistance.Īppendix A – Important Notice in Exchanging SD Card (Micro SD). Additional settings through connection to the Admin Page. Install Speco-NVR and set IP parameters on OiD4. įactory Default Switch.įunctional Description. Party responsible for compliance could void the user’s warranty. Increase the separation between the equipment and receiver.Ĭonnect the equipment into and outlet on a circuit different from that to which the receiver is connectedĬonsult the dealer or an experienced radio/TV technician for help.Īny changes or modifications in construction of this device which are not explicitly approved by the Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Penetration of the moisture through the wire for extended period can cause malfunction of the unit or deteriorated image. The screw holes for the installation screws and pipe should be maintained water tight during the whole life time of the product.Īll the electrical connection wires running into the unit should be prepared so that water from the outside cannot flow into the unit through the surface of the wires. Particular attention is needed when installing the unit. Use only power adapters compatible with the unit.īe careful to prevent moisture or water penetration into the unit. No after service is assumed when disassembled. Especially keep the device out of reach from children.ĭo not disassemble the camera. ![]() Be careful not to cause any physical damage by dropping or throwing the camera.
0 Comments
Leave a Reply. |